Zeda belt drive

[INTP_ty]

https://zedamotorsports.com/

Scroll down to the bottom.

Look harder.

Thoughts? No more grease slingin’

 

[CrazyDan]

I'm not seeing a lip on the big pulley to keep the belt from rolling off.

 

[INTP_ty]

I'm not seeing a lip on the big pulley to keep the belt from rolling off.

Same here.

I’m excited to see it though! Belts are more quiet than chains. & they’re cleaner too!

 

[Spare_Parts]

I just got an email about it. Pedal drive chain is my spare engine drive chain.

 

[LewieBike]

I'm not seeing which engine this is meant to mount to. Is it a primary reduction from the engine's clutch shaft of a 4 stroke?

 

[Spare_Parts]

It's for the pedal side.

 

[Old Busted Hotness]

No way to adjust the length, either. If it's too long or too short for your bike/motor, tough. It's going to require a very precise alignment to keep the belt on, and its performance over bumps (bike frames do flex) is a big question mark.

Quieter, lighter and cleaner than a chain, but reliability is pretty questionable IMO.

 

[curtisfox]

I would like this if i had a 2 stroke, really tough. Have a similar setup on my lawn tractor mower deck to drive the blade...........Curt

 

[zean]

Excuse me curtisfox. I think that tensioner is not appropriate for a belt. It should be a strong spring loaded type. Even with that after a little bit of wear the belt could jump some teeth at the small drive gear when you pop the clutch to start the engine. Am I right about that?

 

[Spare_Parts]

Well I was wrong. Thought the email said pedal side.