I have a 66cc BikeBerry bottom end and a Zeda DioReed top end, ported W/ high compression head and expansion chamber. (Just Rebuilt)
Can only get it running for a few minutes before it dies, hardly any throttle response and won't really rev, and lots of oil spitting out the exhaust. Its also is always backfiring out the exhaust, idle and all other rpm's.
has a #105 main jet & a #38 idle Needle clip in the middle 20/1ish fuel mix
I'm almost certain it's running rich, I was also wondering if these symptoms could be caused by failing reed valves.
The pictures shown are about 5 minutes running w/ choke on and off.
Can only get it running for a few minutes before it dies, hardly any throttle response and won't really rev, and lots of oil spitting out the exhaust. Its also is always backfiring out the exhaust, idle and all other rpm's.
has a #105 main jet & a #38 idle Needle clip in the middle 20/1ish fuel mix
I'm almost certain it's running rich, I was also wondering if these symptoms could be caused by failing reed valves.
The pictures shown are about 5 minutes running w/ choke on and off.