intheclear
New Member
I'm installing a pull start and eventually a centrifugal clutch on my bike.
When I install the pull start, I have to take off the nut that sits in front of the magneto. However pulling the nut causes the wheel to turn and probably the piston to go... how do I lock the engine so I can get the nut off without damaging anything?
Also, the pull start is large. It will hit the pedal if I put it on. Is there anyway to extend the bike pedals? I can't do much about engine placement... its the highest it will go.
Any help-appreciated.
-Greg
When I install the pull start, I have to take off the nut that sits in front of the magneto. However pulling the nut causes the wheel to turn and probably the piston to go... how do I lock the engine so I can get the nut off without damaging anything?
Also, the pull start is large. It will hit the pedal if I put it on. Is there anyway to extend the bike pedals? I can't do much about engine placement... its the highest it will go.
Any help-appreciated.
-Greg