any sheave that can accommodate two belts?

[SunkyWorks]

I picked up one of these, almost new, on ebay. In a "lot" of used pulleys. Cost was $5.

SPEED SELECTOR PULLEY, SPRING LOADED
http://www.plccenter.com/en-US/Buy/SPEED SELECTOR/4C

 

[butterbean]

Are you offering it for sale to me? Is it for a 5/8 shaft? You paid $5 for it, I'll give you $30 if it fits a 5/8 shaft.

 

[SunkyWorks]

Bore measures .625", pulley OD 4" dia, pulley tapering ends at 1.5" dia.

3.5" length fully collapsed.
If you could push adustment shaft out (slotted shaft at bottom of pic), 2.75" length fully collapsed.

Spring is MISSING.

Model 4.C on sticker.

Half of the pulley looks like this. (This is not the part) Painted green, not plated.

 

[butterbean]

I'm going to need to check the speeds of those ratios. I'm not at my computer atm to run a gear ratio calculator. If I decide I want this, the spring missing is going to lower my offer to $25 shipped.

 

[butterbean]

Well, the two speed idea is on hold for now. I got laid off and don't know when I will have the money for all the parts I need, so I'm going to make what improvements I can to my existing setup and save what money I'll have left after that.