I need a new bike!

Discussion in '2-Stroke Engines' started by 247Jude, Apr 9, 2009.

  1. 247Jude

    247Jude Member

    Uhgg repacing the exhaust so much I striped the exhaust manifold studs right out of the block! I could only find 8 mm repacement studs which is too big, going to go to custom bolt shop but don't have time to make it there before the long weekend! No bike for over a week now, am already exibiting withdrawl symtoms, it will be another, six days, uggh!
     

  2. cooltoy

    cooltoy Member

    This reminds me of when I had to wait for a part from the States. That was when I decided to get a second bike going, I never want to go without transportation again.
    Why not just find a metric bolt? If it's too long cut it and make a stud. If you find a bolt of the proper length just use it as you would any bolt, just make sure it's not too long or it may bottom out and even break the case.
    As a guy from Ontario, finding a "french" (metric) bolt should be easy.
     
  3. srdavo

    srdavo Active Member

    the 6mm hole can easily be tapped to 1/4" SAE , If you have access to that size.
     
  4. 247Jude

    247Jude Member

    Will check to see if I have the corect tap, thanks will be checking tonight.
     
  5. 247Jude

    247Jude Member

    Can hardly wait to try it out, if I screw it up I have pleanty of 8mm studs, a bit more work enlarging every other hole but I will be mobile again!
     
Loading...