i just got this shakyness on my bike today i think the conecting rod bearings are failing. it usuallt runs up to 7000rpm and could go even more but on a bike with a 36 sprocket thats fast enough for me till i buy a super good quality bike. today the highest i could get it is to about 6200rpm.
what does it sound like when they fail or wear out?
i also think it may be the chain i did notice there was a little more movement in it than before.
how much slack should it have in it? i keep it about 1/8 inch of up and down on the top side
i have about 45 hours on this motor is that normal for failure of internals?
also can someone check my rpm/speed for me ive riddin next to cars and passed the police radar a few times and at 43-4400 rpm im going 25(i think)
thanks in advance for any help.
what does it sound like when they fail or wear out?
i also think it may be the chain i did notice there was a little more movement in it than before.
how much slack should it have in it? i keep it about 1/8 inch of up and down on the top side
i have about 45 hours on this motor is that normal for failure of internals?
also can someone check my rpm/speed for me ive riddin next to cars and passed the police radar a few times and at 43-4400 rpm im going 25(i think)
thanks in advance for any help.