I removed the stock exhaust & cut a poo-poo pipe in half. Then connected both ends using some aluminum seat tube pieces, Permatex gasket maker, flex p
Sausage closeup. Using a bicycle stem to clamp the flex pipe to the threaded section of the muffler (permatex gasket maker on the threads). Also the s
Changed the muffler to a 'sausage type' ACE hardware special (made for Briggs & Stratton type engines). Better exhaust flow & nice deep throaty sound
Changed the exhaust to a cutoff extended poo-poo pipe (poo-poo muffler is quiet but restrictive)
I removed the stock exhaust & cut a poo-poo pipe in half. Then connected both ends using some aluminum seat tube pieces, Permatex gasket maker, flex p
Still playing with the belt tensioner to figure out the best way to keep the belt tight enough to prevent slippage on hard acceleration, & loose enoug
Cut about an 1" off of each side of the handlebars
my other MB
lowracer

I removed the stock exhaust & cut a poo-poo pipe in half. Then connected both ends using some aluminum seat tube pieces, Permatex gasket maker, flex p

There are no comments to display.

Media information

Album
Latest pics of Lifan Rear rack (no weld) MB
Added by
lowracer
Date added
View count
669
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top