A project I need some advice on

[plinko]

I have an old moped and want to mount the morini 3 horsepower engine to a bike.But,I have no Idea what to do or how to do It.Any advice would be appreciated. And I do have all the accessories from my second grubee kit.Will this work or what do I need to do?

 

[210061741]

Sell me the moped.

 

[plinko]

Not happening.This Is one project I wanna do.I just trying to figure out how to mount the motoe to the bicycle and what steps I need done.buy a used one off ebay

 

[210061741]

Ya sorry i couldnt help myself.

Well first your going to need to test fit the engine in the bike frame.
After you figure out how you want it to sit you will need to make brackets to bolt to the engine and the frame.
Make sure the drive sprocket is aligned right.

Also would be good to find out what RPM the clutch engages at.

After you do that you will need to determine the proper size sprocket for the rear wheel.
This sprocket will be based of your need for speed vs troque.
And obviously will need to conform within the operating range of the engine.

So make some mounting plates.
bolt that baby up to the bike.
Put the properly calculated gear on the rear wheel.
Slap on the chain.

And have some fun.

 

[plinko]

Gee.Not as hard as I thought It would be.Thank you 210061741

 

[210061741]

If you need details let me know.
I can help.

 

[plinko]

Gonna be a few weeks before I start It.I'll keep you posted