artmaker
Active Member
Hi again you bike people.
So… last fall I finished replacing my clutch, whole new transmission, new chain since the gears were different. Then found out my rear bearings were shot… whole new wheel later….
Never got to test any of this. (darn wheel wasn't done till mid winter.)
So… I have a full gas tank that's old. before I even try to start the bike though it would be a wise idea to simply replace the gas. (old stuff will be fine to get my fire pit started.)
I know someone posted this long long ago but I can't find it.
Is there (I'm sure there is) WHERE is there the easiest way to drain the old gas?
Do I really have to pull that skinny gas line off the motor and let it drip into a can?
Or is there a nice simple release valve somewhere I don't know about.
Pretty sure mine is a hushang motor… 4 stroke. I can run out and get a photo of it if need be.
Thanks in advance.
So… last fall I finished replacing my clutch, whole new transmission, new chain since the gears were different. Then found out my rear bearings were shot… whole new wheel later….
Never got to test any of this. (darn wheel wasn't done till mid winter.)
So… I have a full gas tank that's old. before I even try to start the bike though it would be a wise idea to simply replace the gas. (old stuff will be fine to get my fire pit started.)
I know someone posted this long long ago but I can't find it.
Is there (I'm sure there is) WHERE is there the easiest way to drain the old gas?
Do I really have to pull that skinny gas line off the motor and let it drip into a can?
Or is there a nice simple release valve somewhere I don't know about.
Pretty sure mine is a hushang motor… 4 stroke. I can run out and get a photo of it if need be.
Thanks in advance.