JUST IN! BILLET / ALUM. 3 POINT [Drive Gear] MOUNT for : OCC & Coaster REAR Hub

Discussion in 'Dealer Advertisements' started by Manic Hy-per, Dec 1, 2012.

  1. Manic Hy-per

    Manic Hy-per Motored Bikes Sponsor


  2. wheelbender6

    wheelbender6 Well-Known Member

    Will that 3 pt sprocket mount work with the dreaded 60 spoke wheels (like Micargis)?
     
  3. Manic Hy-per

    Manic Hy-per Motored Bikes Sponsor

    Have not tried yet - you could be the first... If the micargi is a coaster brake rear wheel the inside dia. of the mount will probably fit the hub = 1.50 inches... the 3 legs of the mount are about 1.75" inches from the center [which is the wider bolt array based on the manic / pirate adaptor] So I could not say for sure if it will fit? You will need 5/8 inch space between the spokes at 1.75" inches from center (axle) if spokes are that far apart at that point - it should work...Thanks for asking
     
Loading...