Schwinn All Belt Q-Matic

I think I built with help(Reynolds Weld Lab)thanks George and Lee(EZMotorbike)my daily ride. Need to get a offset seat post and a front drum brake wheel and should be fine. http://s971.photobucket.com/albums/ae199/RusticoRay/April 2010/All Belt EZM-A/

 

[azbill]

lookin good Ray !!!

 

[vegaspaddy]

hi ray, SOLID.... that should keep you on the road for a long time to come..

I like the postion of the headlamp out the front, how did you attach it, to the handlebars themselves or to the stem, i would love to see a close up shot, i am pulling my hair out trying to come with a clean mount for my light and signal setup up front.

 

[KilroyCD]

That is one good looking bike Ray!

 

[RusticoRay]

hi ray, SOLID.... that should keep you on the road for a long time to come..

I like the postion of the headlamp out the front, how did you attach it, to the handlebars themselves or to the stem, i would love to see a close up shot, i am pulling my hair out trying to come with a clean mount for my light and signal setup up front.

vegaspaddy,
The light is for looks only, its not hooked up to a battery. It's from advanced auto parts 12volt tractor light. It came with mounting hardware and I attached it to the stem. I'll take a pic later today for you.

 

[vegaspaddy]

no matter, working or not still looks the bomb on there...

once i get my wifes trike sorted out i will start attacking my bike at full force still under wraps and parts scattered all over the place.

 

[Irish John]

How does it perform and are there problems with the belt touching the tyre?

 

[RusticoRay]

How does it perform and are there problems with the belt touching the tyre?

It performs very well, its not fast of the line but a very stable setup. With the HS 50cc it tops out at 32-34 mph. A little more if I lean down and get out of the way. It is tight, no problem it's not touching the tyre but I did have to tweek the upper and lower stays on both sides. 3 3/4" to start and 4 1/4" when done.