Carb bracing

[WEEDHOPPER420]

I have a 21mm pwk carb on a standard reed valve intake,so of course it sticks way out the side.
Its abit flimsy just clamped to the hose adapters, so im looking to brace it and need ideas.
So i guess im asking.... How do yall do yours???

 

[DieselTech]

Some more pictures would help us all.

 

[WEEDHOPPER420]

I just ziptide a small piece of metal rod to it .
Feels alot better than it was, figured it'll work till i find a more elegant solution lol

 

[WEEDHOPPER420]

I know to much tubing but the carb that came with it was junk and this one is bigger than the the original and i haven't gotten around to ordering the proper adapters yet

 

[DieselTech]

I just ziptide a small piece of metal rod to it .
Feels alot better than it was, figured it'll work till i find a more elegant solution lol

It works right! You could make a clamp or even buy a clamp to go around the top tube of your bike frame & then make a small bracket & bolt it to the top tube with the clamps & bracket.

 

[DieselTech]

I would use a couple of these. You will have to measure your top tube & you intake size.

Then you will need to order the appropriate sizes.

Then you can make a flat bar bracket with a couple bolt holes & bolt it all up.

 

[GW's Motorized]

If you can fabricate a brace that bolts to the float bowl bolts that would work

 

[robe]

Zap straps are your friend. I've found the best off set is only as good as how may times you catch it with your heel.

 

[WEEDHOPPER420]

Its my thigh that gets mine lol
My occ sits LOWWWW