Doh and double doh!

[Al Regresar]

I used to use an old motocross trick: a little gas melts the rubber. You would have to cut them off but it was cheap insurance. Nothing worse than being airborne, coming down to earth, and having your grip slip…

 

[Wrench]

Is there anything that someone can use that will allow the grip to easily be removed if need be, but that doesn't slip once installed?-Gearhead437

If your jumping your M/B or the hand grips are still loose (twist) they should be glued on for safety reasons
Of course if ya use glue, when removing the grips they will have to be cut off,

To easily put on or remove your grips compressed air is what the pros use
Most of us don't have an air compressor to put our grips on or take em off
Spit or Windex dries fast and won't glue the hand grips on
To remove the grip, on each side of the grip, stick a long thin flat head screwdriver down between the grip and handlebar,
Then spray some Windex in the void (careful don't poke thru the side or end of the grip) twist the grip to spread the Windex and the grip will slide off
You can even use WD-40 when removing the grips, Some use it to put the grips on too but it takes a ling time for the WD-40 to dry

 

[cloakedvillain]

Is there anything that someone can use that will allow the grip to easily be removed if need be, but that doesn't slip once installed?-Gearhead437

Lock on grips

 

[gearhead437]

Lock on grips

Great idea, but do they make the extension for the throttle cable actuation?-Gearhead437

 

[GW's Motorized]

I've heard people like to use the lock grips and a thumb throttle

 

[gearhead437]

Very interesting-I will research this. Appreciate the tip-Gearhead437