danlandberg
Active Member
I think the front adapter mount is allowing too much flex! I square the rear mount to the seat post then do the front mount. But the rear mount keeps dropping down the tube, even with hose clamps above & bellow mount spacer! I'm going to remove the engine today, repair the rear stud AGAIN (3rd time on this engine) only one stud this time! And I'm going to remove the pressed metal clam shell piece from the front mount to let the front mount bolts to hit the frame! this might eliminate flex. The front adapter mount I made for my Royce Union was flat plate and did not allow any flex! I don't think I'll be riding soon though, quit running again Went on a 30 mile ride yesterday got home and then went to the store 1/2 mile away and it quit running the MAG went again! Going to put a meter on it today & check ohm readings. + fix the flat rear tire! I'm am so mad at this piece of I am about ready to throw it off my second story balcony!!! That would be the easiest way to get it down stairs This MICARGI / Flying Horse piece of