Brakes help needed

[Roger Kyle]

Guys I'm picking up where I left off on my first build back in 2018! Long story short I had some health issues, as a result I have some pretty bad memory issues. I can't remember much of what I did on this bike already or what my plan was. As to my brake question, I had already put this caliper bracket on it, but I can't seem to find what I planned to use for brakes. I tried to find a hydraulic caliper, but the mounting orientation doesn't seem right. Can anyone point me in the right direction of what I should use?

 

[DieselTech]

Do you got a disc brake wheel on that bike now?

 

[Roger Kyle]

Do you got a disc brake wheel on that bike now?

No, but I do have a threaded disc adapter to go on the hub

 

[DieselTech]

No, but I do have a threaded disc adapter to go on the hub

So are you using a rear wheel on the front?

 

[cloakedvillain]

So are you using a rear wheel on the front?

I can see the threads. Picture isn't the best. Those adapters should work well enough at least for the speeds these bikes should be ran when used like this since braking while going forward will put a clockwise rotational force on the adapter.

 

[cloakedvillain]

That's an iso disc brake tab if that helps. Not sure what size rotor will fit without seeing one mounted though

 

[Roger Kyle]

So are you using a rear wheel on the front?

That's correct

 

[Roger Kyle]

I can see the threads. Picture isn't the best. Those adapters should work well enough at least for the speeds these bikes should be ran when used like this since braking while going forward will put a clockwise rotational force on the adapter.

Added more pics

 

[Roger Kyle]

I added more/better pics

 

[DieselTech]

I added more/better pics

What size rotor were you planning on using on the the front of your bike? Thanks. Also could you get us bolt spacing on your caliper bracket. Measure from the center to center of the bolt holes & post it in mm. Thanks.