G
Ghost0
Guest
I made it from a regular brake lever. Cut a piece of 1/4" aluminum, screwed it into where the cable adjuster goes. Drilled and tapped 2 new holes and put in two new cable adjusters. Then I drilled a hole where the cable end goes, got a piece of steel the same diameter, cross drilled 2 holes in it and ran it through the handle. Kinda a lot of work, especially since you can buy dual pull handles for about $15.
http://cgi.ebay.com/DUAL-BRAKE-LEVE...5611230QQcmdZViewItem?_trksid=p3286.m20.l1116
http://cgi.ebay.com/DUAL-BRAKE-LEVE...5611230QQcmdZViewItem?_trksid=p3286.m20.l1116
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.