A little vtwin

[DieselTech]

I sure hope that engine works good, because in the future you can have that case copied and start selling it.

Yeah I'm curious at what degrees the second cylinder hits/fires?

 

[DieselTech]

Well you were right. They have bearings 3mm thinner. which should solve my problem. Only problem is I now been tempted by the ceramic bearings .

I would stay away from ceramic on engine bearings. But that's me!

 

[FrankHorrigan6]

I sure hope that engine works good, because in the future you can have that case copied and start selling it.

That’s my plan. Get it scanned and mod it to take 66cc China doll part. That way you can run more common parts and can convert it to saw or minarelli.

 

[Wrench]

Minarelli Cylinders are available again

 

[FrankHorrigan6]

Minarelli Cylinders are available again

Do they bolt on to 50cc stud spacing?

 

[Wrench]

Do they bolt on to 50cc stud spacing?

$199 Minarelli Motors

Just a heads up that me, California Motorbikes, is back in stock of our Minarellis after months of being sold out. $199.

motorbicycling.com

 

[FrankHorrigan6]

Not sure what he did to this poor engine. I had to hammer out the wrist pins on both side. The rods are gouged to hell.

 

[Jayraye39]

Could you imagine dual Frankenstien ms660 top ends on that thing. Be like 30hp. The V-Frank.

 

[GW's Motorized]

Could you imagine dual Frankenstien ms660 top ends on that thing. Be like 30hp. The V-Frank.

I don't think the gears would hold up to that

 

[Whitewill1412]

I hope this thing actually works