francisjohn
Active Member
Out of both crank seals, I am only having this problem with the thicker main seal that's under the small bevel gear.
I am struggling with pressing the ID of the seal in.
-I have tried using sockets (15mm)
-Trying to press the ID before the seal is seated in the case.
-Tried pressing the ID once the seal is seated in the case.
What do you do? or is everyone else running around here with their ID's flipped outwards?
I am struggling with pressing the ID of the seal in.
-I have tried using sockets (15mm)
-Trying to press the ID before the seal is seated in the case.
-Tried pressing the ID once the seal is seated in the case.
What do you do? or is everyone else running around here with their ID's flipped outwards?