6blueoval9
Well-Known Member
No..just pedal it around for a few.it should shoot up out of the plug hole...you might try turning the bike upside down if you wanted...it should come out that way as well.
Help please motor won't start
- Thread starter Travis David Greene
- Start date
6blueoval9
Well-Known Member
This gives me an idea to maybe drill and tap a small hole and use a bolt for such occasions I can unscrew to drain from the crank case if needed..lol
Last edited:
Travis David Greene
Member
That sounds like a pretty good idea haha. Although that does give it a chance to rattle out
Travis David Greene
Member
I got the bike to run but there was nothing inside the crankcase or the cylinder. I flipped it over and nothing came out so I reassembled it and now it turns over and starts. Here are three vids of it running. I don't think it sounds very good but at least it runs now
6blueoval9
Well-Known Member
Motors fairly quiet...I can't get audio from the vids...lol
Travis David Greene
Member
You try turning up your volume? I can hear it on my phone
6blueoval9
Well-Known Member
Yes.
Travis David Greene
Member
Positive its not muted through the player then? Because I justt checked again and i can hear them all on my phone. I can try re-uploading them if you want
Travis David Greene
Member
When riding I was holding throttle up a bit but my idle is set to the lowest it can go without stalling out. I was holding the clutch in because I tightened the flower nut a little too much. Sprocket is 41 tooth
Similar threads
