Avenger 85 gaskets

[Soulfly]

Does anybody know I'd phantom 85 base gaskets and yd100 head gaskets would work on the avenger 85?

 

[ImpulseRocket]

You need to measure the stud spacing. If they are 50mm, then a yd100 gasket will work.

 

[mony0_3]

The gaskets are the same, I put my Avenger85 top end on a YD100 bottom end.

 

[Soulfly]

The gaskets are the same, I put my Avenger85 top end on a YD100 bottom end.

Thanks man.

 

[DAMIEN1307]

I put my Avenger85 top end on a YD100 bottom end.

What happened to the bottom end that came with the Avenger motor kit???

 

[Whitewill1412]

What happened to the bottom end that came with the Avenger motor kit???

Maybe he just bought the top end

 

[mony0_3]

What happened to the bottom end that came with the Avenger motor kit???

The bevel gear crank seal was leaking and I didn't want to wait for new seals!

 

[DAMIEN1307]

The bevel gear crank seal was leaking and I didn't want to wait for new seals!

@Deleted member 35519 had the same problem with the bottom end as reported on another thread and Zane admitted to him that this is the problem with what Zane calls the so-called "Phantom Killer", Avenger motor.

Likewise I verified with him the problem with his motor bottom ends are the oil seals and beaings.. Their seated too close out of the box. Poor quality control. He offered no support to replace anything. Yet.

 

[mony0_3]

@Deleted member 35519 had the same problem with the bottom end as reported on another thread and Zane admitted to him that this is the problem with what Zane calls the so-called "Phantom Killer", Avenger motor.

So far, the yd100 bottom is holding and screaming! Also had to replace the clutch pads with the green ones.