Interesting - Grubee's Bearing Belt Tranny Design

[Deleted Member 4613]

I learned that the Grubee belt tranny uses four bearings in the clutch bell
housing, two on each end. They are 6202-RS, 15x35x11mm, rubber sealed.
Looks to be a very solid design over Chinese belt trans. that employs a
simple brass bushing. I don't know how they are installed.

 

[DieselTech]

I learned that the Grubee belt tranny uses four bearings in the clutch bell
housing, two on each end. They are 6202-RS, 15x35x11mm, rubber sealed.
Looks to be a very solid design over Chinese belt trans. that employs a
simple brass bushing. I don't know how they are installed.

I havent taken a grubee trans apart yet, but the drive gear removes off of the snout of clutch bell, then you can press out clutch bell, then the 4 bearings are pressed into the transmission housing.