Random ebay kit only missing carb cover?

[Sumsloppymeet]

found this on ebay and bought it for 45$ supposidly its only missing the carb cover any info or what not possibly it was sold by a MadCheetah itll be here tomorrow figured it will be a good fit to sell?

 

[crassius]

from apparent size of motor mounts, I'd say it was a 66cc or 70cc, new style bottom end - I see no indication of the top half of the motor in the pics

if you read on the forum here, you'll find that many folks struggle quite a bit finding a top end that fits even if they have the old one to measure

 

[Sumsloppymeet]

yea to start its mount studs were damn near L shaped from being shipped lol its a 60cc aosom con rod ZMN the cylinder studs are 6mm thinking about shipping it back lol

 

[crassius]

bummer, from the pic I thought motor mounts were 8mm as they seemed about the size of the cylinder studs - if all are 6mm, then that motor could be any size from 49cc to 66cc (though 60cc is VERY rare)

unless you feel adventurous, you might want to return it

 

[Sumsloppymeet]

its definitly a 45mm 3ring flat topp piston everything i find says its the 60cc from aosom is it good bad orr hidden gem maybe if its rare i found the top end for it for 30$
https://www.ebay.com/itm/45mm-60cc-...ash=item2354b5e7b1:g:XJkAAOSwEW9acWY2&vxp=mtr

 

[crassius]

I'm not at shop right now, so can't look at a blown out 60cc I took in trade just to make measurements from - I'll post agaim later

 

[crassius]

OK, I was wondering if I've become so old that I'd not notice three rings on the 60cc 45mm piston - the one here is 45mm, but has only the usual two rings.

60cc is so rare here, that I can't give you much info about which fits what.

 

[Sumsloppymeet]

The topend showed up from China today here's the 3 ring piston the cylinder looks like a great cast not many flaws I see just needs a lil porting and clean up will have more pictures soon I'm working on three motors right now so little busy lmao

 

[Sumsloppymeet]

its done True 60cc aosom upgraded with graphite bushing and minor porting and knifeing of cylinder with upgraded hardware except case screws dont need to split the case right now other than that its stock

 

[crassius]

graphite bushing?

haven't heard of that before on these