graggy
Active Member
The tabs on the strap to hold the rear motor mount on aren’t big enough for the nut and washers to sit on flat. Plus if I keep tightening it down I’ll probably be bending the studs on the motor. Anyone have this issue and what is a good way to fix this? I thought about putting washers on the studs to pack it out to the strap So I didn’t bend the studs. I would have to grind a flat on the washers because there isn’t enough room from the stud to the frame for a whole washer to fit. And I would still have the issue of the washers and nut not sitting flat on the strap. Any suggestions would be appreciated.