I’m Going to build a “Zeda Frankenstein” Motor that has a Stihl ms660 cylinder & piston.
I’m putting this here Incase someone is looking into building one and can’t find enough info.
The bolt holes on a ms660 are further out than what’s standard on a motorized bike. To fix this I’m filling in the old thread holes with low temp aluminum brazing rod and retapping new ones, while I’m doing that I’m also going to have to fill in the transfers along with stuffing the crankcase.
Low temp rod ( 2mm thick 20pcs )
Cheap china 56mm top end
Other thread
I’m putting this here Incase someone is looking into building one and can’t find enough info.
The bolt holes on a ms660 are further out than what’s standard on a motorized bike. To fix this I’m filling in the old thread holes with low temp aluminum brazing rod and retapping new ones, while I’m doing that I’m also going to have to fill in the transfers along with stuffing the crankcase.
Low temp rod ( 2mm thick 20pcs )
Cheap china 56mm top end
Other thread
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.