Found a rack mount kit on ebay

Will'smotobikes19

Well-Known Member
Local time
7:10 PM
Joined
Apr 9, 2018
Messages
2,505
Location
United States
This seems to be an alternative to friction drive and maybe my bike would be able to use it. Just replace the brake disc with a sprocket and hope theres enough room for the chain. I think I have a 36 tooth or 38 tooth 6 hole sprocket laying around. Any 76mm clutch engine should work.

 
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.
Will that's interesting, never seen that before. Priced right, wonder what connects those to drive gears in the tranny box. Chain, belt or gears. Is that the same tranny on HT kits? Is it a reliable tranny?
 
I found one that I had from a mini chopper, needs a new gasket and nut for the clutch bell and new bolts since I lost them. I tried taking it apart but I think you put gear oil in these. Looks more reliable than the tiny chain drive components.
 

Attachments

  • 17039704610291171713104136744829.jpg
    17039704610291171713104136744829.jpg
    204.6 KB · Views: 46
  • 17039707291067642580135126130525.jpg
    17039707291067642580135126130525.jpg
    131.3 KB · Views: 42
I found one that I had from a mini chopper, needs a new gasket and nut for the clutch bell and new bolts since I lost them. I tried taking it apart but I think you put gear oil in these. Looks more reliable than the tiny chain drive components.
That's a different tranny from the looks of it, right?
 
That's a different tranny from the looks of it, right?
I had one similar to the kit gearbox but its for 415 chain it was on a huasheng it was junk the shaft kept pulling out because there's nothing stopping it from sliding out except a key it would walk about 3/8 inch almost coming out
 

Attachments

  • 17039739344512395221445837272260.jpg
    17039739344512395221445837272260.jpg
    142.2 KB · Views: 42
Had an idea that was the case, wasn't sure. So with the kit on Ebay a new tranny would be needed.
 
Had an idea that was the case, wasn't sure. So with the kit on Ebay a new tranny would be needed.
It would still bolt to a gx50 or the mitsu clone since the cag engines use the same clutch diameter It is adjustable to get the right alignment since it has the u bracket with 3 bolts like my friction drive kit.
 
If my friction drive kit doesn't work I'll probably pull the trigger on this kit. Do you think the disc brake could be swapped with a sprocket? Here is the bike
 
Links to eBay may include affiliate code. If you click on an eBay link and make a purchase, this forum may earn a small commission.
Back
Top