Rodney kaylor
New Member
Excuse me
I built ones of these GT90 conversion motors. Got it done, but it won't start?
Its getting spark, good plug, lighting bolt CDI.
Can I ask you, when you put the throttle cable on,
Did it fit!
Mine seem to be too short?
It held the carb. About half way on, it seemed?
I made it where the sliding part, goes all the way down?
But now I'm thinking mabe I was wrong?
Mabe needs more air going through?
By raising the sliding part.
I built ones of these GT90 conversion motors. Got it done, but it won't start?
Its getting spark, good plug, lighting bolt CDI.
Can I ask you, when you put the throttle cable on,
Did it fit!
Mine seem to be too short?
It held the carb. About half way on, it seemed?
I made it where the sliding part, goes all the way down?
But now I'm thinking mabe I was wrong?
Mabe needs more air going through?
By raising the sliding part.