Hey Guys

Discussion in 'Introduce Yourself' started by yellowbeard, Feb 6, 2011.

  1. yellowbeard

    yellowbeard New Member

    New here, just finished up a Grubee 66cc skyhawk on my bike. Chranked it up for the first time for a short ride down the road. A couple of problems with it. The clutch is hard to pull. and it idles fine but when I give it a little gas it bogs down. Is there some ajustment that I need to do to the carb. Thanks Joe



  2. yellowbeard

    yellowbeard New Member

    just checking

    do the new threads go to new post for viewing? thanks
  3. Dave C

    Dave C Member

    I was going to say, "clean installation but a close(well, not so close) look tells me I should just say Hi.;)

    As I still haven't taken time to learn the photo thing I can't help you there.
  4. yellowbeard

    yellowbeard New Member

    the install was not finished when i took the pics.
  5. yellowbeard

    yellowbeard New Member

    Dave, reread your reply, no need to be rude, As you can see it's not finished. Your old enough to know better.
  6. rob johnson

    rob johnson Member

    hi joe, iam in the same boat or bike as you. the carb and engine looks the same as my two new 48cc on wal-wart op rollers. (same bogging)friday iam tuning carbs with the imfo. i got from this great forum in my intro.
  7. Stan4d

    Stan4d New Member

    New posts are just that....new posts. Yes your thread will be there while it has new posts.....but if your looking for your thread it is best to scan the section you started it in.

    On your carb problem this thread should help: http://www.motoredbikes.com/showthread.php?t=24867

    Hope to see the finished pick when you get a chance, Clean start in the pics and I am sure that you did well on the follow through.

    I don't think any rudness was intended....but the post seemed to lead others to think that the pics were of a finished bike, so there was the confusion.