Sprocket Alignment on Schwinn Cruiser (Typhoon)

[srdavo]

About the engine mount.... That is quite a space to fill. The studs are not even long enough without going lower

Kronic's right about the engine mountiong blocks & longer studs. Rusty is the same style frame. I put an extra block on the rear mount & the front mount. Fits very well.
IMHO, I'd do what I could to use both, the fenders & the chain guard. It's a beautiful bike!
keep us posted on your progress.

 

[thatsdax]

look out !!!!

That long bolt between the front motor mount and the bike needs to be filled with flat washers and then compressed against the bike or the front mount will break. To see how this is done, go to www.thatsdax.com and go to page 3 of install at the bottom of the page.. I hope this helps you....