chrisnbush
Member
The shaft is too short - looks like DAX saws them off maybe. But it also looks like it might be too narrow.
The GRUBEE instructions say the shaft needs to be 15.8 mm dia x 33.5 mm long. I actually can't be sure the Titan shaft is too narrow until I get the DAX clutch shoe mounting plate off the shaft.
Got all the shoes + springs off OK, and the bolt off the end of the shaft + washer, but the triangular shaped mount is still on the shaft, and firmly. I expect this is keyed, and so it is pressed on ?
Sure wouldn't want to use a torch on that momma to try to get it off. Bye Bye engine (and maybe me).
Any advice (or does anyone want a Titan cheap ?)
Thanks
Chris Bush
The GRUBEE instructions say the shaft needs to be 15.8 mm dia x 33.5 mm long. I actually can't be sure the Titan shaft is too narrow until I get the DAX clutch shoe mounting plate off the shaft.
Got all the shoes + springs off OK, and the bolt off the end of the shaft + washer, but the triangular shaped mount is still on the shaft, and firmly. I expect this is keyed, and so it is pressed on ?
Sure wouldn't want to use a torch on that momma to try to get it off. Bye Bye engine (and maybe me).
Any advice (or does anyone want a Titan cheap ?)
Thanks
Chris Bush