Thanks for the compliments, guys!
Large Filipino- To mount the tank, I just took the clamp pieces, turned them upside down, and attached them to the frame with 1/4-20 stove bolts through a hole I drilled in the center of each one. Then I just bolted the tank to the clamps like it would be normally.
Lynn- I wish I could take credit for the paint! I was told this bike had limited production of around 1500 units or so.
azkronic- You are right about the pipe being loud! I changed that, though. I made a baffle for it by cutting a peice of 1/2" conduit about 8" long. Drilled a bunch of holes in it. Welded a 1/2" flat washer on each end and ground the washers down to a size that would slide in the end of the pipe. I then wrapped the conduit with fiberglass pipe insulation between the washers and secured it with some wire. Shoved the whole thing in the end of Barry's pipe and ran a small sheetmetal screw through the backside of the pipe so it wouldn't come out. Brought the noise down to a tolerable level and provided a little needed back pressure.
Mike