Anyone know where I can get phatmoto parts or did I get duped?

Rocky

New Member
Joined
May 31, 2019
Messages
24
New frame,preferably unfinished,chain tensioners,5/8” jackshaft with set screws,new 36 tooth jack shaft sprocket,new 10tooth(I think) drive sprocket that goes along with jackshaft,and a new rear rim. Thanks
 
X

XFOLLY

Guest
Anyone know where I can get phatmoto rover parts or did I get duped?
I JUST FINISHED PUTTING IN A NEW 212CC PREDATOR MOTOR IN MY PHATMOTO, UNBELIVEABLE. WENT WITH A TORQUE CONVERTER. UNBELIVEABLE
PACKAGE.
 

MotoMagz

Active Member
Joined
Dec 19, 2008
Messages
514
I JUST FINISHED PUTTING IN A NEW 212CC PREDATOR MOTOR IN MY PHATMOTO, UNBELIVEABLE. WENT WITH A TORQUE CONVERTER. UNBELIVEABLE
PACKAGE.
Just be careful if that’s a aluminum frame..always check for cracks with 212.T. Converter should keep you rpms under 5 grand if you remove govner.
 

CrazyDan

Well-Known Member
Joined
Jul 9, 2016
Messages
3,183
I wish I knew how to weld (and had a welding machine). I want a steel phatmoto frame, with power on the right side to shift.
 

Frogslayer

Well-Known Member
Joined
Jan 20, 2019
Messages
2,576
I can weld and have access to aluminum welder and steel welder and still don't have one yet so don't feel too bad ;)
 
Top