artmaker
Active Member
I hope someone is on here. Need help ASAP.
I dropped my bike, broke the hand brake off the clutch brake thing I have.
Got a new on today from ebay, trying to install it and ran into a problem.
Please see the attached image, not sure what this is called.
That spring arm thing that puts the motor in gear?
I could swear that was swung OUT and pulling the cable would put the bike in neutral, and that arm would be flat or in line with the motor, as in the picture.
Put the bike in gear, and it springs out.
Well... now mine is set so if I connect it, to put this bike in gear would have to pull that bar all the way up against, oh what ever that part is where the cable actually runs through? Looking at that picture, it would be bumping up against that post where the cable goes. And neutral would be in the position in the picture.
WHAT did I do? And how do I fix this?
I dropped my bike, broke the hand brake off the clutch brake thing I have.
Got a new on today from ebay, trying to install it and ran into a problem.
Please see the attached image, not sure what this is called.
That spring arm thing that puts the motor in gear?
I could swear that was swung OUT and pulling the cable would put the bike in neutral, and that arm would be flat or in line with the motor, as in the picture.
Put the bike in gear, and it springs out.
Well... now mine is set so if I connect it, to put this bike in gear would have to pull that bar all the way up against, oh what ever that part is where the cable actually runs through? Looking at that picture, it would be bumping up against that post where the cable goes. And neutral would be in the position in the picture.
WHAT did I do? And how do I fix this?