Some questions (images)

Joined
Apr 8, 2022
Messages
51
Got a 100cc engine kit, instructions are not clear, I have a couple questions:

1. Ignition box has 2 female cables: black and red. They have 2 slots on the red, and 2 slots on black.

The throttle male cable appear crimped and do not stay inside the ignition box cables (they slide out right away)... Where do they go? There are only 4 female slots, and 5 male cables.

2. theres a threaded bolt on the spark plug (see on and off pic), do I remove this or keep on?

3. How exactly do you start the bike engine? Do I just start peddling and it auto starts?

4. Which way does the gas filter go? (see pic of what I believe is correct)
 

Attachments

  • 1.jpg
    1.jpg
    193.8 KB · Views: 43
  • 2.jpg
    2.jpg
    162.7 KB · Views: 43
  • 3.JPG
    3.JPG
    34.3 KB · Views: 42
  • 4.jpg
    4.jpg
    174.2 KB · Views: 46
  • 5.jpg
    5.jpg
    178.6 KB · Views: 44
  • 6.jpg
    6.jpg
    114.2 KB · Views: 47

Mossy

Well-Known Member
Joined
Jan 7, 2022
Messages
2,648
The 3 master link is for those cut twice and patch once type builds
 

Attachments

  • Screenshot_20220409-192442.png
    Screenshot_20220409-192442.png
    234.7 KB · Views: 28

DAMIEN1307

Moderator
Staff member
Joined
Jul 23, 2020
Messages
5,183
By the way, the gasket on the engine is pretty torn up (the same side where the flower nut is). Is it important I replace this? What is the purchase of this gasket here? I dont think this side of the engine has any pressure as its the clutch / gear box area, is it to keep dirt / water out? Any suggestions on a material I can use to DIY replace? May trace out some rubber and slide it in, if not any sources I can buy a replacement gasket?

Gonna give this a ride tomorrow, excited.
This is what I replaced my gasket with...Cheap enough and has been reusable without tearing on me.

 
Top