linnix13
Member
i over tightened the bolt going into my engine. it stripped the female input on the engine. can i put alot of loctite in there or is there a type of industrial sealant or glue i can put in there because if you know what theses HT engines are like its a bolt that goes in thru the ehaust and into the engine block. theres not much of a gap and it almost threads but its just to stripped. thanks and im fine with putting it in and making it permanent because its a threaded rod not a bold, you put the nut on the end after its been threaded into the engine and you put the muffler on. thanks again