Happy Valley
Active Member
When you mounted your housing, where does the spindle line up in relation to the rear wheel? Looking at the right side of the rear wheel, does the spindle fall top dead center over the axle in the 12 o'clock position, or forward or backward from that position?
In my attempt to keep the kit and motor fairly level on the mountain bike frame I'm using, (and the pre-drilled holes) it looks like the drive spindle will fall rearward a couple of inches from TDC over the axle. (maybe 11:30 or so)
Think it matters?
In my attempt to keep the kit and motor fairly level on the mountain bike frame I'm using, (and the pre-drilled holes) it looks like the drive spindle will fall rearward a couple of inches from TDC over the axle. (maybe 11:30 or so)
Think it matters?