Looking for "65CC" cylinder, and piston + rings

Something that would replace the DAX "D" model cylinder, the studs are 6mm on this one.

I have the wrist clips and the wrist pin.

Thanks

 

[BSA]

I would contact dax and ask him as his engines are unique, and there is no other compatible cylinders availible.

BSA

 

[chrisnbush]

Well he doesn't have any

at least in stock now. Still looking for a type "D" cylinder, or if someone has something they believe will work I might be interested.

If the cylinder fits on the lower unit, AND the piston fits on the wrist pin+ bearings, AND the ring keepers keep the rings ends out of the ports , AND the piston travel doesn't exceed the top of the cylinder (!) I might be alright, right ?

The cylinder I have is 6 mm stud, I am thinking I could even use 8mm stud cylinder as replacement. Why not ? The cylinder sleeve that extends would center the cylinder on the bottom unit, although I would need some kind of spacers in the bolt holes in the cylinder head extending into the cylinder bolt holes - spacers like 8mm OD, 6mm ID.

Hey, I don't go fast...

Thanks

cb