darwin
Well-Known Member
- Local time
- 5:22 AM
- Joined
- May 26, 2008
- Messages
- 8,052
Any suggestions on attaching a Staton f/d support arm here into 1 of the 2 existing screw holes. I'm thinking using washers or a spacer to do it. Don't know if it will be strong enough though. There's only enough room to screw the bolt in flush w/the back side of the axle support, maybe 1/4in. If the support was flush it would be cool. I'm thinking the support will need a 1/2 to clear the caliper. Hard to tell this is the only pic I can locate of the area. Any suggestions?
Last edited: