S
Scottm
Guest
I think I just figured it all out by trial and error I'll see when I get a new carb cable.
The ends of the throttle cable sheaths or outters will not go into or stay in their connector screw on the throttle handle. Does the inner metal sheath need to be cut back even with the plastic sheath with the metal tip on the end?
The inner metal sheath is about 1/2 longer than the plastic sheath.
The cluch handle connector just clamps around the sheath end with a squeeze from pliers. The throttle connector is solid and nice and smooth on the inside.
Thanks.
The ends of the throttle cable sheaths or outters will not go into or stay in their connector screw on the throttle handle. Does the inner metal sheath need to be cut back even with the plastic sheath with the metal tip on the end?
The inner metal sheath is about 1/2 longer than the plastic sheath.
The cluch handle connector just clamps around the sheath end with a squeeze from pliers. The throttle connector is solid and nice and smooth on the inside.
Thanks.
Last edited by a moderator: