Exhaust Baffle removal?

Discussion in '2-Stroke Engines' started by Guest, Apr 26, 2007.

Tags: Add Tags
  1. Guest

    Guest Guest

    O.K., this so called "expert" is having trouble removing the baffle from the exhaust.

    I used a rubber mallet, heat ect, no joy.

    How does everyone else remove theirs? Do most just fall out when you take the screw out?

    I can hear "stuff" rattling around in there before I've even run the engine and want to clean it out.

  2. azbill

    azbill Active Member

    I took the screw out and let pressure do the work :p
  3. JosephGarcia

    JosephGarcia Guest

    EXACTLY!!! I heard that rattling for the first time for 30 minutes before the engine vibration finally knocked it out, and it fell out totaly when I removed that little end cap dealie. Only happened past 35 MPH though.

    Try running your engine, or put the muffler into a paint shaking machine. lol.
  4. gone_fishin

    gone_fishin Guest

    if you don't mind a few teethmarks, use large channellocks to twist & a small hammer to provide a bit of vibration to the job. cut the small tube off right down to the nub. the cap's a lot easier to re-install than remove.
  5. Guest

    Guest Guest

    I fired it up today and a bunch of crud blew out. I think it's loud enough the way it is. Maybe after it's broken in I'll mess with it.

    For now, I'll just "enjoy the ride" 8)
  6. Dockspa1

    Dockspa1 Guest

    I shook my brand new muffler from AppleBig just after removing it from the bag and whadya know, SHAKE n FLAKES. I was curious and looked into the gas tank and found quite a bit of rust.
    Thats bad when you have to blow out a brand new pipe!
    P.S. Seen on the package " was MFG. 2005 and tested 10 minutes.
    Hurray for the test but a little wd 40 spray would have been nice afterword.