Hello,
How do I know when the main spring has lost tension?
The Other day I was riding my bike going alone as good as my bike ever go's I gave it a little extra throttle a couple of times made it home parked the bike then decided to go back to town not good about 2.4 miles I started up a hill and I thought the clutch was slipping bad the motor was revved up but nothing so I came home cleaned the pads and plate with alcohol tried again same problem.To day I put new pads in black ones there was a little grease on the back of the pads I cleaned every thing well and it was actually worst then before What I noticed is I can push the bucking bar in easy with my hand it use to take a little effort also it seems every time I get the cable right I need to tighten it more push the bucking bar in and tighten the cable set screw. The Clutch Plate moves when I push the Bucking bar in. I have replaced the pads before I used the black pads to replace the one's that came with the motor I got about 600 miles out of them. The Picture of the plate is to see if I should replace it's pretty much been as pictured except the smooth outer area. One last question can anyone point me to a good guide to change the spring and make any suggestions on what else I might need to replace like gaskets and other stuff.
Sorry for the long storie and bad grammer
How do I know when the main spring has lost tension?
The Other day I was riding my bike going alone as good as my bike ever go's I gave it a little extra throttle a couple of times made it home parked the bike then decided to go back to town not good about 2.4 miles I started up a hill and I thought the clutch was slipping bad the motor was revved up but nothing so I came home cleaned the pads and plate with alcohol tried again same problem.To day I put new pads in black ones there was a little grease on the back of the pads I cleaned every thing well and it was actually worst then before What I noticed is I can push the bucking bar in easy with my hand it use to take a little effort also it seems every time I get the cable right I need to tighten it more push the bucking bar in and tighten the cable set screw. The Clutch Plate moves when I push the Bucking bar in. I have replaced the pads before I used the black pads to replace the one's that came with the motor I got about 600 miles out of them. The Picture of the plate is to see if I should replace it's pretty much been as pictured except the smooth outer area. One last question can anyone point me to a good guide to change the spring and make any suggestions on what else I might need to replace like gaskets and other stuff.
Sorry for the long storie and bad grammer