I won’t have to spread her legs to get the wheels in the frame, but the axles it came with are too big for my dropouts. Front is a motorcycle fork with 10mm dropouts and the rear can take a 10mm axle but the axles it came with won’t fit front or rear. I don’t want to modify my dropouts, so I took the bearings out of one of the hubs (same size on both wheels), measured them and went on eBay and found high speed engine bearings that are the same OD and width as the ones I took out, with a 10mm ID and they were only $25 for 4 of them, they’re rated to over 20k rpms so I think they’ll be fine for my wheels lol. Might never have to change them again haha.